Tile Roof Replacement in Summit Valley from $6,000. Tile handles this climate well. The felt underneath it does not. Free inspection and a written quote.
Wind through the pass lifts tile, and lifted tile is cracked tile by the time anyone looks. Expect a higher breakage allowance on a Summit Valley roof than on the valley floor, stated up front, and expect the ridge and hip fixings to be specified rather than left to whatever is standard.
Concrete tile is a genuinely good choice in the High Desert. It does not care about ultraviolet the way asphalt does, it holds its shape through the daily thermal cycle, and it is heavy enough that wind uplift is rarely the problem it is on a lighter covering.



A lift and relay -- your own tile back down over new underlayment -- runs $6,000 to $16,000 here against $22,000 to $45,000 for a full replacement. Specify a high-temperature underlayment when you do it: standard felt is what failed, and putting the same thing back buys you the same interval again. The most exposed ground covered here, so expect the fastening and edge-fixing specification to carry a real cost -- and expect it to be worth it. Permits are county, and many parcels are on their own well.
If the tile is sound and only the felt beneath has failed, the relay is the right job at roughly a third of the cost. We count the salvageable tile before quoting either.
Concrete does not care about ultraviolet the way asphalt does, holds its shape through the daily cycle, and is heavy enough that wind uplift is rarely the problem. It is the covering this climate argues for.
A relay quoted with standard felt. In an attic that runs well over a hundred degrees for months, that is the component that just failed -- and reusing the same spec is why some roofs get relaid twice in twenty years.
Summit Valley is the most exposed ground covered on this site. Wind funnelling through the pass is stronger and more sustained than on the valley floor, which makes the fastening specification the single most important line on a quote here. Long-span shelters are the other common job, and those are low slope with their own ponding problems.
Summit Valley properties frequently fall outside the water district and depend on a private or shared well, and the permit route is San Bernardino County.
This is a replacement company saying so. In the High Desert the expensive mistake is buying a new covering when the problem was the felt, the fastening or the ventilation.
Concrete tile handles this climate well. Standard felt in a hundred-degree attic does not. A tile roof quoted at $22,000 to $45,000 is very often a $6,000 to $16,000 relay -- with a high-temperature underlayment this time.
What lets go out here is usually a fixing or a lap that the wind has worked on for a season, and putting it right is a few hundred dollars. It is also the commonest opening for a replacement pitch, which is a different conversation entirely.
And roofs do finish out here, all at once, after enough seasons of wind and sun. When that is the answer we will give it -- and show you the slope it is based on.
This is the most exposed ground on the site.
Where a property sits outside the water district and runs on a well, the cooling load matters more than usual because evaporative cooling is not a free option.
This is where fastening decides everything.
Wind uplift on a low-slope roof is about perimeter fixing and edge detail, not the field, and Summit Valley is the place on this site where that matters most.
Wind damage up here is localized by nature -- it takes the exposed slope and leaves the sheltered one -- so a single-slope partial is the common and correct job.
Zone 14. Wind and a forty-degree daily swing.
Building since 1971. Dust, wells and wide lots.
Civic Plaza and Main Street. Commercial low slope.
Unincorporated. Newer houses, busier geometry.
Higher, colder, and more than one roof per parcel.
Its own city, and a lot of multi-family.
A Town, not a city. Barns as often as houses.
Asked on every job of this kind. Answered here.
Because the leak is under it. Concrete tile outlasts the felt beneath it by decades anywhere, and an attic that runs well over a hundred degrees for months widens that gap. The felt tears and goes brittle while the tile above still looks new from the road.
A high-temperature product, not standard felt. Standard felt is what just failed, and specifying it again buys you the same interval a second time. This is the single most important line on a High Desert relay quote and it is frequently missing.
Four documented exceptions: an addition under 300 square feet of roofing, an attic radiant barrier, R-20 or better attic insulation, or properly sealed ducts. Out here the insulation route is usually the better buy anyway -- it cuts the cooling load rather than reflecting a fraction of it, on a house that runs air conditioning five months a year.
For longevity, generally yes. Concrete tile ignores the ultraviolet that destroys asphalt, holds its shape through the daily cycle, and is heavy enough that uplift is rarely the issue. The catch is the underlayment beneath it, which needs to be a high-temperature product rather than standard felt.
No. The inspection is free, the written quote is free, and there is no obligation attached to either. What we will not do is give you a price at the door, or quote a cool roof without first looking in the attic to see whether an exception already applies.
Free inspection, and a written quote against a written scope. Fastening pattern specified for wind, not left to the minimum.