Shingle Roof Replacement in Summit Valley from $5.50. The covering this climate is hardest on, installed for wind rather than to the minimum. Free inspection and a written quote.
This is where fastening decides everything. A four-nail minimum passes inspection and does not survive a Summit Valley spring, where the wind comes through the pass sustained rather than in gusts. Six nails in the correct zone, specified on the quote -- it costs very little and it is the whole difference.
Composition shingle has the shortest life of any covering in zone 14, and the reason is mechanical rather than thermal. The daily expansion and contraction of a forty-degree swing works the mat until it cannot recover, so you see curling at the edges and granule loss across whole slopes years before the warranty period is up.



Composition runs about $5.50 to $8.50 per square foot in the High Desert, below the Los Angeles basin because labor is cheaper here. What should not be shaved is the fastening: a high-wind nailing pattern adds very little to that figure and is the single biggest factor in how long the roof lasts. The most exposed ground covered here, so expect the fastening and edge-fixing specification to carry a real cost -- and expect it to be worth it. Permits are county, and many parcels are on their own well.
A single-layer tear-off onto sound plywood, a simple roof shape, and a color whose aged rating is comfortably compliant.
A second existing layer, a steep pitch, an exposed lot needing the full high-wind specification, or a dark color that needs a premium product to meet the aged minimum.
Warranties are written for an average American climate. A forty-degree daily swing cycles the mat until it cannot recover, so judge the roof by its condition rather than by the years left on paper.
Summit Valley is the most exposed ground covered on this site. Wind funnelling through the pass is stronger and more sustained than on the valley floor, which makes the fastening specification the single most important line on a quote here. Long-span shelters are the other common job, and those are low slope with their own ponding problems.
Summit Valley properties frequently fall outside the water district and depend on a private or shared well, and the permit route is San Bernardino County.
This is a replacement company saying so. In the High Desert the expensive mistake is buying a new covering when the problem was the felt, the fastening or the ventilation.
If the complaint is an unbearable upstairs rather than a leak, attic ventilation and insulation will do more than any covering -- and R-20 insulation happens to exempt you from the cool-roof requirement as well.
What lets go out here is usually a fixing or a lap that the wind has worked on for a season, and putting it right is a few hundred dollars. It is also the commonest opening for a replacement pitch, which is a different conversation entirely.
And roofs do finish out here, all at once, after enough seasons of wind and sun. When that is the answer we will give it -- and show you the slope it is based on.
This is the most exposed ground on the site.
Where a property sits outside the water district and runs on a well, the cooling load matters more than usual because evaporative cooling is not a free option.
Wind through the pass lifts tile, and lifted tile is cracked tile by the time anyone looks.
Wind uplift on a low-slope roof is about perimeter fixing and edge detail, not the field, and Summit Valley is the place on this site where that matters most.
Wind damage up here is localized by nature -- it takes the exposed slope and leaves the sheltered one -- so a single-slope partial is the common and correct job.
Zone 14. Wind and a forty-degree daily swing.
Building since 1971. Dust, wells and wide lots.
Civic Plaza and Main Street. Commercial low slope.
Unincorporated. Newer houses, busier geometry.
Higher, colder, and more than one roof per parcel.
Its own city, and a lot of multi-family.
A Town, not a city. Barns as often as houses.
Asked on every job of this kind. Answered here.
It is legal up to a limit and it is a bad idea here for a specific reason: you cannot fasten reliably through two layers into the deck, so the new covering has worse wind performance than the old one did. In a climate where wind is the main hazard, that is the wrong trade.
It can. The requirement is on the aged solar reflectance in the CRRC listing, and the darker end of most ranges is where it gets marginal. Pick the color you want, then check its listing rather than assuming.
Four documented exceptions: an addition under 300 square feet of roofing, an attic radiant barrier, R-20 or better attic insulation, or properly sealed ducts. Out here the insulation route is usually the better buy anyway -- it cuts the cooling load rather than reflecting a fraction of it, on a house that runs air conditioning five months a year.
For longevity, generally yes. Concrete tile ignores the ultraviolet that destroys asphalt, holds its shape through the daily cycle, and is heavy enough that uplift is rarely the issue. The catch is the underlayment beneath it, which needs to be a high-temperature product rather than standard felt.
No. The inspection is free, the written quote is free, and there is no obligation attached to either. What we will not do is give you a price at the door, or quote a cool roof without first looking in the attic to see whether an exception already applies.
Free inspection, and a written quote against a written scope. Fastening pattern specified for wind, not left to the minimum.